| Model |
S-200-24 |
| Output |
DC Voltage |
24V |
| Rated Current |
8.3A |
| Current Range |
0 ~ 8.3A |
| Rated Power |
200W |
| Ripple & Noise (max.) Note.2 |
240mVp-p |
| Voltage Adj. Range |
21~28V |
| Voltage Tolerance Note.3 |
±1.0% |
| Line Regulation |
±0.2% |
| Load Regulation |
±0.2% |
| Setup,Rise, Hold time |
100ms, 50ms at full load |
| Input |
Voltage Range |
88 ~ 132VAC/176 ~ 264VAC selected by switch 248 ~ 370VDC |
| Frequency Range |
47~63HZ |
| Efficiency(Typ.) |
85% |
| AC Current |
3.2A/115VAC 1.6A/230VAC |
| Inrush Current (max.) |
COLD START 35A |
| Leakage Current |
<3.5mA / 240VAC |
| Protection |
Over Load |
105 ~ 150% rated output power |
| Protection type : Shut down o/p voltage, re-power on to recover |
| Over Voltage |
30V~34.8V |
| Protection type : Shut down o/p voltage, re-power on to recover |
| Environment |
Working Temperature |
-10 ~ +60°c (Refer to output load derating curve) |
| Working Humidity |
20~90% RH Non-condensing |
| Storage temp.& humidity |
-20~+85°C, 10~95%RH |
| Temp. coefficient |
±0.03%/°C (0~50°C) |
| Vibration |
10 ~ 500Hz, 2G 10min./1 cycle,60min.each along X,Y,Z axes |
| Safety & EMC |
Safety Standards |
UL1012, UL60950-1, TUV EN60950-1, CCC GB4943 approved |
| (Note 4.) |
Withstand Voltage |
I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC |
| |
Isolation Resistance |
I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC |
| |
EMI Conduction & Radiation |
Compliance to EN55022 (CISPR22) Class B |
| |
EMS IMMUNITY |
Compliance to EN61000-4-2,3,4,5,6,8,11; ENV50204, EN55024, Light industry level, criteria A |
| Others |
MTBF |
286.7K hrs min. MIL-HDBK-217F (25°c ) |
| Dimension |
199*110*50mm (L*W*H) |
| Packing |
0.8Kg; 16pcs/13.8Kg/0.95CUFT |
| Note |
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. |
| 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. |
| 3. Tolerance : includes set up tolerance, line regulation and load regulation. |
| 4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. |
